Floor Stripping Auto Scrubber

• To remove all soil, floor finish from the floor before applying new floor finish.

• Automatic floor machine with pad driving assembly or brush

• General purpose mop

• Mop bucket with wringer

• Squeegee with handle

• 3M Floor pads

• Putty knife

• Dust mop

• Dust pan and brush

• Approved floor stripper

1. Prepare equipment

Fill solution tank with correct floor stripper solution. Fill mop bucket one-half with clean water. . . Transport equipment to work site.

Set up "Wet Floor" signs. . . Move obstacles such as furniture.

Follow Procedure 2. . . Use clean dust mop.

Using maximum brush pressure and leaving the squeegee in an up position generously spread the floor stripping solution. . .Allow the solution to set on the floor for recommended time. . . Do not allow to dry.

Follow Procedure 6.

Scrub floor with maximum brush pressure, squeegee down. Check rate of speed to insure complete removal of all old finish. . . Remove any puddles with wet mop or squeegee to a point that can be reached by the Automatic.

Remove any remaining stripping solution from machine...Refill with clean water...Replace floor pad if used or rinse brushes...Using a medium brush pressure double scrub as described above. . . No waiting time between passes.   Remove puddles.

Kellermeyer Company  -  Your Best Source For, Ohio Commercial Janitorial Supplies